Manual Whirlpool W9 OP2 4S2 H Forno

Manual

EN

7

10. TOOLS

Press to open the “Tools” menu at any time. This

menu enables you to choose from several options

and also change the settings or preferences for your

product or the display.

REMOTE ENABLE

To enable use of the 6

th

Sense Live Whirlpool app.

KITCHEN TIMER

This function can be activated either when using a

cooking function or alone for keeping time. Once

started, the timer will continue to count down

independently without interfering with the function

itself. Once the timer has been activated, you can also

select and activate a function.

The timer will continue counting down at the top-right corner

of the screen.

To retrieve or changhe the kitchen timer:

• Press

.

• Tap

.

An audible signal will sound and the display will

indicate once the timer has finished counting down

the selected time.

• Tap “DISMISS” to cancel the timer or set a new

timer duration.

• Tap “SET NEW TIMER” to set the timer again.

LIGHT

To switch on or off the oven lamp.

SELFCLEAN

Activate the “Self-Clean” function for optimum

cleaning of the internal surfaces.

It is reccommended to do not open the oven door during the

cleaning cycle to avoid a loss of water vapor that could get an

adverse eect on the nal cleaning result.

• Remove all accessories from the oven before

activating the function.

• When the oven is cold, pour 200 ml of drinking

water on the bottom of the oven.

• Tap “START” to activate the cleaning function.

Once the cycle has been selected, you can delay the start of

automatic cleaning. Tap “DELAY” to set the end time as

indicated in the relevant section.

DRAIN

The drain function allows the water to be drained in

order to prevent stagnation in the tank. For optimal

use of the appliance, it is advisable to always carry

out draining everytime the oven has been used with

a steam cycle.

Once selected the “Drain” function,

follow the actions indicated: Open

the door and place a large jug

under the drain nozzle located

at the bottom right of the panel.

Once started the draining, keep the

jug in position until the operation

is completed. The average duration for full load

drainage is about three minutes.

If needed, it is possible to pause the draining process

by tapping PAUSE on the display (for example in case

the jug would be already full of water in the middle of

the draining process).

The jug must be at least 2 liters large.

Please note: to ensure that the water is cold, it is not possible

to perform this activity before 4 hours have elapsed from the

last cycle (or the last time the product was powered). During

this waiting time, the display will show the following feedback

“WATER IS TOO HOT: WAIT UNTIL THE TEMPERATURE

DECREASES”.

Important: If the tank is not regularly drained, after

a few days since the last refill, the appliance will

ask to do it displaying the message <

DRAIN CYCLE IS

NEEDED

>: this request can not be ignored, and it will

be possible to continue with the normal use of the

product only after the drain has been carried out.

DESCALE

This special function, activated at regular intervals,

allows you to keep the tank and the steam circuit in

the best condition.

The message <

DESCALE CYCLE NEEDED> will be

shown on display, to remind you to execute this

operation regularly.

Descale requirement is triggered by the number of

steam cooking cycles performed or steam boiler

working hours since the last descale cycle (see the

table below).

“DESCALE” MESSAGE appears after WHAT TO DO

15 cycles of steam cooking

Descale is recommended

22 hours of steam cooking duration

20 cycles of steam cooking

It is not possible to run a

Steam cycle until a Descale

cycle will be carried out

30 hours of steam cooking duration

The descaling procedure can also be performed whenever

the user desires a deeper cleaning of the tank and the internal

steam circuit.

The average duration of the full function is around

180 minutes. Once the function is started, follow all

the steps indicated on the display.

Please note: The function can be paused but, if it is canceled

at any time, the entire descaling cycle must be repeated from

the beginning.

» DRAINING (up to 3 min.)

When the display will show <PLACE A CONTAINER

BELOW THE WATER DRAINING HOLE>, please proceed

with the draining task as described in the dedicated

Drain paragraph. If the tank does not contain water,

the appliance will skip automatically to STEP 1 OF 8.

Please note: to ensure that the water is cold, it is not possible

to perform this activity before 4 hours have elapsed from the

last cycle (or the last time the product was powered). During

this waiting time, the display will show the following feedback

“WATER IS TOO HOT: WAIT UNTIL THE TEMPERATURE

DECREASES”.

Avaliação

Mais sobre este manual

Entendemos que é bom ter um manual em papel para o seu Whirlpool W9 OP2 4S2 H Forno. Você sempre pode baixar o manual em nosso site e imprimi-lo você mesmo. Se desejar um manual original, recomendamos que entre em contato com Whirlpool. Eles podem fornecer um manual original. Você está procurando o manual do seu Whirlpool W9 OP2 4S2 H Forno em outro idioma? Escolha o seu idioma preferido em nossa página inicial e pesquise o número do modelo para ver se o temos disponível.

Especificações

Todos os manuais para Whirlpool Fornos
Mais manuais de Fornos

Perguntas frequentes sobre Whirlpool W9 OP2 4S2 H Forno

Nossa equipe de suporte pesquisa informações úteis e respostas a perguntas frequentes sobre produtos. Se você encontrar algum dado incorreto em nossas perguntas frequentes, informe-nos usando nosso formulário de contato.

Produtos relacionados

Manual

Whirlpool AKP9 140 C IX Forno

Manual

Whirlpool W7 OM5 4S P Forno

Manual

Whirlpool AKP 311/01 AP Forno

Manual

Whirlpool AKP 287/NA Forno

Manual

Whirlpool AKZ9S 8271 IX Forno

Manual

Whirlpool AKP 446/WH Forno

Manual

Whirlpool AKP 451/WH Forno

Manual

Whirlpool AKP 380/IX Forno

Categorias relacionadas