Manual Zanussi ZHT611W Exaustor

Manual

2

www.zanussi.com

Recommendations

and suggestions

• The Instructions for Use apply

to several versions of this ap-

pliance. Accordingly, you may

nd descriptions of individual

features that do not apply to

your specic appliance.

• The manufacturer will not be

held liable for any damages

resulting from incorrect or

improper installation.

• The minimum safety distance

between the cooker top and

the extractor hood is 650 mm

(some models can be installed

at a lower height, please refer

to the paragraphs on working

dimensions and installation).

• Check that the mains voltage

corresponds to that indicated

on the rating plate xed to the

inside of the hood.

• For Class I appliances, check

that the domestic power supply

guarantees adequate earthing.

Connect the extractor to the

exhaust ue through a pipe

of minimum diameter 120 mm.

The route of the ue must be

as short as possible.

• Do not connect the extractor

hood to exhaust ducts carrying

combustion fumes (boilers,

replaces, etc.).

• If the extractor is used in

conjunction with non-electrical

appliances (e.g. gas burning

appliances), a sufcient degree

of aeration must be guaranteed

in the room in order to pre-

vent the backow of exhaust

gas. The kitchen must have

an opening communicating

directly with the open air in

order to guarantee the entry

of clean air. When the cooker

hood is used in conjunction

with appliances supplied with

energy other than electric,

the negative pressure in the

room must not exceed 0,04

mbar to prevent fumes being

drawn back into the room by

the cooker hood.

• The air must not be discharged

into a ue that is used for ex-

hausting fumes from applianc-

es burning gas or other fuels

(not applicable to appliances

that only discharge the air back

into the room).

• In the event of damage to

the power cable, it must be

replaced by the manufacturer

or by the technical service de-

partment, in order to prevent

any risks.

• If the instructions for installa-

tion for the gas hob specify

a greater distance specied

above, this has to be taken

into account. Regulations

concerning the discharge of

air have to be fullled.

• Use only screws and small

parts in support of the hood.

Warning: Failure to install

the screws or xing device in

accordance with these instruc-

tions may result in electrical

hazards.

• Connect the hood to the mains

through a two-pole switch hav-

ing a contact gap of at least

EN

Avaliação

Mais sobre este manual

Entendemos que é bom ter um manual em papel para o seu Zanussi ZHT611W Exaustor. Você sempre pode baixar o manual em nosso site e imprimi-lo você mesmo. Se desejar um manual original, recomendamos que entre em contato com Zanussi. Eles podem fornecer um manual original. Você está procurando o manual do seu Zanussi ZHT611W Exaustor em outro idioma? Escolha o seu idioma preferido em nossa página inicial e pesquise o número do modelo para ver se o temos disponível.

Especificações

Todos os manuais para Zanussi Exaustores
Mais manuais de Exaustores

Perguntas frequentes sobre Zanussi ZHT611W Exaustor

Nossa equipe de suporte pesquisa informações úteis e respostas a perguntas frequentes sobre produtos. Se você encontrar algum dado incorreto em nossas perguntas frequentes, informe-nos usando nosso formulário de contato.