Manual Rosières RDR 91/2 AV Exaustor

Manual

replaced. To restart the hour counter (RESET), hold the button A pressed down for about 1” (while the pilot lamp

S is on). Button B: drives the motor in first speed (the corresponding pilot lamp comes on); when holding it down

for about 1”, the motor cuts out; when pressing the button a second time (while the pilot lamp is on) , the TIMER

is activated and thus the motor stops after 5’ (the pilot lamp flashes). Button C: drives the motor in second speed

(the corresponding pilot lamp comes on); when pressing the button a second time (while the pilot lamp is on) ,

the TIMER is activated and thus the motor stops after 5’ (the pilot lamp flashes). Button D: drives the motor in

third speed (the corresponding pilot lamp comes on); when pressing the button a second time (while the pilot lamp

is on) , the TIMER is activated and thus the motor stops after 5’ (the pilot lamp flashes). Button E: drives the

motor in fourth speed (the corresponding pilot lamp comes on); when pressing the button a second time (while

the pilot lamp is on) , the TIMER is activated and thus the motor stops after 5’ (the pilot lamp flashes).

Pay special attention to the grease filters; to remove the filter: push inward on the clamp at the handle and

pull the filter downward. Wash out the filter using a neutral soap. if the model purchased has the controls shown

in Figure 13: see the paragraph “Controls shown in Fig. 13” (“Filter Alarm”). If the model purchased has the controls

shown in Figure 11/12: the grease filter must be cleaned periodically: exactly how often depends on use (at least

once every other month). If the model purchased has the controls shown in Figure 14: the grease filters must

be cleaned approximately once every 30 hours of operation (when the light button lamp comes on) - Fig. 14S).

Once the cleaned filters are reinstalled, to reset the counter hold the light button pressed down for about 1”

(Fig.14A) while the corresponding pilot lamp (S) is on. For further information, see the Controls in Fig.14 in the

paragraph entitled “Operation”.

Charcoal filter/s: if using the hood in the filtering hood, the charcoal filter must be replaced periodically. To

remove the charcoal filters, proceed as follows, depending on the model purchased:

- if the hood features round charcoal filters (Fig. 15), remove the charcoal filter by turning clockwise.

- if the hood features a panel type charcoal filter (Fig. 10), remove the charcoal filter by first of all removing the

two filter retainers M.

If the model purchased has the controls shown in Figure 13, see the paragraph “Controls shown in Fig. 13” (“Filter

Alarm”). If the model purchased has the controls shown in Figure 11/12, the charcoal filters must be replaced

according to use: on the average once every 6 months. If the model purchased has the controls shown in Figure14,

the charcoal filters must be replaced each time the light button (Fig.14S) lamp flashes (i.e. every 120 hours of

operation).

Lighting:

- To gain access to the bulbs, remove the grease filters as described above and remove the bulbs. Replace only

with CANDLE HALOGEN LAMP - Ø 35mm, E14–220-240 Vac, 28W or INCANDESCENT LAMP-E14–220-240 Vac,

40W

- If the halogen lamps shown in Fig. 16 need changing, slacken the ring nut in an anticlockwise direction and

remove the bulb itself. Replace with the same type of lamp. CAUTION: Do not handle glass bulb with bare hands.

- To change the halogen lamps shown in Fig. 17 open the cover levering from the proper slots. Replace with

the same type of lamp. CAUTION: Do not handle glass bulb with bare hands.

The motor used in this hood features a safety device (thermal cutout) that responds to temperature changes

For accidental reasons or due to installation faults, this device could engage and automatically shut off the

motor, thereby preventing serious damage to the equipment. In such cases, after allowing the motor to cool

down, the hood can be switched on again; the cause of the fault will nonetheless have to be remedied,

ensuring installation has been correctly made and that all the instructions in the Information sheet have been

complied with.

Avaliação

Mais sobre este manual

Entendemos que é bom ter um manual em papel para o seu Rosières RDR 91/2 AV Exaustor. Você sempre pode baixar o manual em nosso site e imprimi-lo você mesmo. Se desejar um manual original, recomendamos que entre em contato com Rosieres. Eles podem fornecer um manual original. Você está procurando o manual do seu Rosières RDR 91/2 AV Exaustor em outro idioma? Escolha o seu idioma preferido em nossa página inicial e pesquise o número do modelo para ver se o temos disponível.

Especificações

Todos os manuais para Rosières Exaustores
Mais manuais de Exaustores

Perguntas frequentes sobre Rosières RDR 91/2 AV Exaustor

Nossa equipe de suporte pesquisa informações úteis e respostas a perguntas frequentes sobre produtos. Se você encontrar algum dado incorreto em nossas perguntas frequentes, informe-nos usando nosso formulário de contato.

Produtos relacionados

Manual

Rosières RHP 675 RB Exaustor

Manual

Rosières RDM 91 IN Exaustor

Manual

Rosières RSHD 90 IN Exaustor

Manual

Rosières RDR 61/2 AV Exaustor

Manual

Rosières RDM 61 IN Exaustor

Manual

Rosières RHG 529 IN Exaustor

Manual

Rosières RHG 527 GR Exaustor

Manual

Rosières RHC 6380 PN Exaustor

Categorias relacionadas