ENGLISH
Explanation of general view
1 Nozzle
2 Blower outlet
3 Suction inlet
4 Dust bag
5 Fastener
6 Switch trigger
7 Lock button
8 Speed control screw
9 Lower
0 Higher
q Limit mark
w Screwdriver
e Brush holder cap
SPECIFICATIONS
Model 4014N 4014NV
Capacities
Air pressure (water column) ........................................................... 560 mm 0 – 560 mm
Air volume ....................................................................................... 2.8 m
3
/min. 0 – 2.8 m
3
/min.
No load speed (min
–1
) ....................................................................... 16,000 0 – 16,000
Overall length .................................................................................... 430 mm 430 mm
Net weight .......................................................................................... 1.75 kg 1.75 kg
•
Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
•
Note: Specifications may differ from country to
country.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC supply.
They are double-insulated in accordance with Euro-
pean Standard and can, therefore, also be used from
sockets without earth wire.
Safety hints
For your own safety, please refer to the enclosed
safety instructions.
These symbols mean:
Read instruction manual.
DOUBLE INSULATION
ADDITIONAL SAFETY RULES
1. Always use protective goggles, a cap and
mask when using the blower.
2. Never point the nozzle at anyone in the vicinity
when using the blower.
3. Always use the dust bag when collecting dust,
chips and the like.
4. Do not collect still smoldering cigarette ashes
or freshly cut metals shavings. Warning –
Electric shock could occur if used on wet
surfaces. Do not expose to rain. Store indoors.
5. Never block suction inlet and/or blower outlet.
Increased motor revolution may cause dan-
gerous fan breakage.
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
Blowing (Fig. 1)
For dust blowing, attach nozzle to blower outlet,
turning clockwise to lock it in place.
Dust suction (Fig.2&3)
Note:
Dust bags are optional accessories in some coun-
tries.
For dust suction, fit nozzle onto suction inlet and dust
bag onto blower outlet.
After the bag fills with dust, empty the contents of the
dust bag into a dust bin by releasing the fastener.
Switch action
CAUTION:
Before plugging in the tool, always check to see that
the switch trigger actuates properly and returns to the
‘‘OFF’’ position when released.
For 4014N (Fig. 4)
To start the tool, simply pull the trigger. Release the
trigger to stop. For continuous operation, pull the
trigger and then push in the lock button. To stop the
tool from the locked position, pull the trigger fully, then
release it.
For 4014NV (Fig. 5)
To start the tool, simply pull the trigger. Tool speed is
increased by increasing pressure on the trigger.
Release the trigger to stop. For continuous operation,
pull the trigger and then push in the lock button. To
stop the tool from the locked position, pull the trigger
fully, then release it.
A speed control screw is provided so that maximum
tool speed can be limited (variable). Turn the speed
control screw clockwise for higher speed, and coun-
terclockwise for lower speed.
3
Participe da conversa sobre este produto
Aqui você pode compartilhar o que pensa sobre Makita 4014NV Soprador de folhas. Se você tiver alguma dúvida, primeiro leia atentamente o manual. A solicitação de manual pode ser feita através do nosso formulário de contato.