English (original instructions)
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
OPERATION
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufcient to inict serious injury.
WARNING
Always wear eye protection. Failure to do so could
result in objects being thrown into your eyes resulting
in possible serious injury.
PREPARATION (See figure 8)
Check the auger has not already taken in snow in
the start position.
Insert the battery in the specific compartment.
Note: Before starting to clear the snow, silicone spray
should be applied to the auger to avoid ice formation on
the rotating units.
SAFETY CHECKS
After start-up and before using the machine, it is
essential to run the following safety tests. Check the
results of the safety checks correspond to those in the
table.
WARNING
Always carry out the safety checks before use.
WARNING
If any of the results fails to match the indications
provided in the following table, do not use the ma-
chine! Take it to a service centre to be checked and
repaired if necessary.
General safety and auger functionality check.
Object Result
Press the ignition key.
Press the starter lever.
The motor starts and the
auger starts to rotate.
Test driving
No abnormal vibrations.
No abnormal sound.
Release the starter
lever.
The motor and auger
stop immediately.
START-UP / OPERATION (See figure 9)
WARNING
The auger starts to rotate when the snow thrower
starts. Keep people a safe distance away and check
the auger is not touching stones or objects that could
be launched.
Departure
Tilt the snow thrower slightly back and lift the auger
slightly from the ground.
Press and keep the starter lever release pressed.
To start, pull the starter lever.
WARNING
If the auger is blocked, do not attempt to operate the
motor. The machine is equipped with an automatic
“Motor save” protection when inserted, wait a few
minutes before re-starting the machine.
Operation
Lower the auger towards the ground and start to re-
move snow.
WARNING
Always stop the motor before proceeding with re-
lease operations.
STOP (See figure 9)
To stop the machine, release the starter lever.
IMPORTANT: If you have to leave the machine, remove
the battery.
ADVICE FOR OPERATION
Snow is removed more easily when it is still fresh.
Pass back over the already cleared zones to
remove snow residue.
If possible, clear the snow in the direction of the
wind. Check the distance and the direction of the
removed snow jet.
In strong winds, lower the delfector to direct the
discharged snow towards the ground, reducing the
likelihood of the wind transporting the snow to the
wrong areas.
Once you have finished work, leave the machine
running for a few minutes to prevent ice from
forming in the discharge chute.
Dry and normal snow
Snow up to 20 cm can be quickly removed by proceed-
ing to evenly clear it away. For deeper or built up snow,
reduce the speed and let the machine work at its own
rhythm.
Participe da conversa sobre este produto
Aqui você pode compartilhar o que pensa sobre Greenworks GD40ST Ventilador de neve. Se você tiver alguma dúvida, primeiro leia atentamente o manual. A solicitação de manual pode ser feita através do nosso formulário de contato.