Manual Fluval 407 Filtro aquário

Manual

EN-9

3. Reassemble unit – DO NOT FILL CANISTER WITH WATER WHEN RE-ASSEMBLING UNIT

1. Place rinsed and filled media baskets back in canister and put cover back on top basket.

2. Replace pre-filter basket in canister. (Insert with flat end down.)

3. Always lubricate motor head gasket using an inert lubricant (i.e. Fluval Silicone Lubricant #A325 or vegetable oil).

4. Replace the cover. Be sure to position it properly. There is only one orientation possible.

5. Use the lock-lift clamps to close the cover securely.

6. Place the unit back in position; re-insert the AquaStop valve, and push down the locking lever to lock it in place.

7. Push down on the valve lever to open the AquaStop valve. Water should start flowing immediately.

IMPORTANT: If the hosing has been disconnected from the AquaStop valve, or if the system has lost its vacuum for some

other reason, the canister will not fill automatically. Use the instant-prime handle to fill the canister.

8. Allow the canister to fill completely, then plug the power cord back into the electrical outlet.

IMPORTANT: If the canister is not full before the filter is plugged in, it may not work properly. The filter unit should never be

allowed to run dry. Running the unit dry may result in damage to the motor.

Impeller Care

The impeller well has an effective self-cleaning feature. However, it is recommended that you remove the impeller cover and inspect

the impeller as part of your routine maintenance. Keeping the impeller clean lengthens its life and the life of the motor.

IMPORTANT: The impeller fan has a ceramic shaft, which is resistant to wear and tear

in use, but is still fragile. Handle carefully during maintenance.

1. Remove the impeller cover: Pull the tab over and gently pry off.

2. If the impeller needs cleaning, grasp the fan and draw it gently from the well.

Rinse it under clean water.

3. If the well needs cleaning, wipe gently with a Fluval Cleaning Brush.

4. Replace the impeller in the well: Slide the impeller cover tab into the tab receptacle on the rim of the impeller chamber. Push

down the opposite side of the impeller cover making sure the impeller starts to seat

itself in the center of the impeller cover. Continue to push down until the retailing

tab “clicks” and locks into position.

NOTE: The ceramic impeller shaft is held on the bottom of the impeller well by a rubber

support. The shaft can be easily extracted and reinserted by hand; however, pay close

attention to be certain the rubber support does not become unseated. (Always replace

the impeller cover to ensure proper alignment).

The impeller will wear out over time. A replacement may be ordered from your local

Fluval dealer or by contacting

Fluval/Rolf C Hagen Inc. customer service.

Primer

Please note Primer handle can only be replaced in the event of breakage of the stem or

handle.

click!

Recycling

This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE).This means that

this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or dismantled to

minimize its impact on the environment. Check with your local Environmental Agency for possible disposal instructions

or take to an official council registered refuse collection point. Electronic products not included in the selective sorting

process are potentially dangerous for the environment and human health due to the presence of hazardous substances.

MAINTENANCE

Avaliação

Mais sobre este manual

Entendemos que é bom ter um manual em papel para o seu Fluval 407 Filtro aquário. Você sempre pode baixar o manual em nosso site e imprimi-lo você mesmo. Se desejar um manual original, recomendamos que entre em contato com Fluval. Eles podem fornecer um manual original. Você está procurando o manual do seu Fluval 407 Filtro aquário em outro idioma? Escolha o seu idioma preferido em nossa página inicial e pesquise o número do modelo para ver se o temos disponível.

Especificações

Todos os manuais para Fluval Filtros aquários
Mais manuais de Filtros aquários

Perguntas frequentes sobre Fluval 407 Filtro aquário

Nossa equipe de suporte pesquisa informações úteis e respostas a perguntas frequentes sobre produtos. Se você encontrar algum dado incorreto em nossas perguntas frequentes, informe-nos usando nosso formulário de contato.

Produtos relacionados

Manual

Fluval 307 Filtro aquário

Manual

Fluval 207 Filtro aquário

Manual

Fluval 107 Filtro aquário

Manual

Eheim Liberty 75 Filtro aquário

Manual

Tetra EX 800 Plus Filtro aquário

Manual

Eheim eXperience 150 Filtro aquário

Manual

Eheim Ecco Pro 2032 Filtro aquário

Manual

Eheim Biopower 200 Filtro aquário

Categorias relacionadas