Manual Bionaire BWM401 Humidificador

Manual

BWM401

Fig.1

A

F

H

G

D

B

E

C

J

L

K

M

N

Fig.2

E

I

A

PLEASE READ AND SAVE THESE

IMPORTANT INSTRUCTIONS.

NOTE: Before reading these instructions,

please unfold the back page for the

corresponding illustrations

DESCRIPTION

Fig.1

A. Lid

B. Medication cup

C. Moisture Outlet

D. Handle

E. Water Tank

F. Air Inlet (Not Shown)

G. Control Panel

H. Base

I. Misting Chamber

Fig.2

J. Display Lens

K. Humidity Set Button

L. Mode/Off Button

M. Refill Light

N. Power Light

HOW YOUR WARM MIST HUMIDIFIER

WORKS

Your Bionaire

®

Warm Mist Humidifier is designed

to allow the proper amount of water to flow out

of the tank and into the Heating Chamber where

the Electronic Thermal Control Heating Element

warms the water. Air is drawn in through the grill

openings located in the back of the unit and

mixed with steam in the misting chamber. The

warm mist is then dispersed out of the top of the

misting chamber through the outlet grill and into

the room.

NOTE: A humidity level below 20% can be

unhealthy and uncomfortable. The recommended

humidity level is between 40%-50%.

PRE-OPERATING INSTRUCTIONS(SEE

FIGS.1 - 2)

1. Be sure the Humidifier is switched to OFF

and the unit is disconnected from the

electrical outlet.

2. Select a location for your Humidifier, on a flat

surface, about 10cm (4") away from the wall.

DO NOT place the Humidifier on a finished

floor on or near furniture which can be

damaged by moisture or water. Place on a

moisture-resistant surface.

Filling the Water Tank

NOTE: This humidifier holds about 4.2 litres of

water in the tank and humidifier base. The

humidifier will produce up to 11 litres of moisture

over a 24-hour period, depending on the room

humidity and temperature.

1. If not already removed, remove the Tank

from the base of the Humidifier and take it to

the cold water tap. Turn the Tank upside

down and twist off the Tank Cap by turning

counter clockwise. Fill Tank with cool, fresh

tap water. DO NOT fill with warm water as

this may cause leaking. Replace the Cap on

the Tank FIRMLY but do not overtighten.

2. When full, carry Tank to the Humidifier and

place onto the Base. The water will

immediately begin to flow into Base.

3. Please wait for five minutes for water

chamber to fill with water from water tank.

4. Plug the power cord into a convenient 220/

240V AC electrical outlet.

OPERATING INSTRUCTIONS (SEE

FIGS.1 - 2)

Your Humidifier is equipped with a

technologically advanced AccuSet™ Digital

Humidistat. You can set the Humidifier to run

continuously in manual mode or set the

AccuSet™ Digital Humidistat to your desired

humidity setting. The AccuSet™ Digital

Humidistat will automatically turn the humidifier

ON or OFF, depending on the preset comfort

level. The comfort level ranges from 35% to 65%

relative humidity.

MANUAL MODE

NOTE: After starting the unit from cold, it will

take 5–10 minutes before any noticeable steam

is emitted from the Outlet Grill.

1. When plugged in, the Display will show the

current room humidity.

2. To start the unit, press the MODE/OFF

Button for the HIGH (HI) manual setting.

3. Press the Button again for the LOW (LO)

manual setting.

4. To stop the unit, keep pressing the Button

until the Display reads OFF (OF).

ACCUSET™ HUMIDISTAT MODE

To take advantage of the AccuSet™ Digital

Humidistat:

1. Press the MODE/OFF button until you reach

AU (Automatic) Accuset.

ENGLISH

2. Adjust the set humidity by using the Humidity

Set Button. The Display will show a setting in

the range 35% – 65% and the humidity can

be increased/decreased in increments of

5%. When the room humidity level rises

above the set humidity, the Humidifier will

stop. When the humidity level drops below

the set humidity, the Humidifier will turn on

automatically.

NOTE: The AccuSet™ Humidifier has memory.

This means that when you turn the unit back on

to AccuSet™ mode, it will remain at the setting

the Humidifier was previously set at, unless the

unit has been unplugged.

REFILL PROCEDURE

NOTE: When the Water Tank is empty and the

water in the Heating Chamber is almost empty,

the Red REFILL light will illuminate, the panel

will display "FILL" and the Automatic Shut Off

will activate.

The unit will not operate again until you refill the

Water Tank and reset the Humidifier as follows.

1. Remove and refill the Water Tank, being sure

to follow the Maintenance Instructions.

Replace the Tank onto the Base.

2. After 5 minutes, turn the unit on. The REFILL

light should now be off (if not repeat steps 1

through to 2)). In about 5 minutes, the

Humidifier will begin to produce moisture.

3. If you do not plan to use the Humidifier for

two or more days, make sure any residual

water is drained from the Water Tank and

Base to prevent algae or bacteria growth.

AUTO SAFETY SHUT OFF

This humidifier is equipped with a

technologically advanced, safety system that

requires the user to reset the humidifier if there

is a potential overheat situation. When a

potential overheat temperature is reached, the

system will automatically shut the humidifier off.

It can only resume operation when the user

resets the unit.

To reset the humidifier

1. Unplug unit, wait 15 minutes.

2. Press the reset button on the bottom

of the unit.

CLEANING AND MAINTENANCE

INSTRUCTION

The following maintenance procedures

must be routinely followed in order to

ensure proper, efficient operation of your

humidifier. The unit WILL FAIL if it is not

cleaned properly.

Regular cleaning prevents scale build-up on the

heating element and tray. It also prevents

microorganisms from growing on the tray and

tank. This ensures that maximum efficiency will

be achieved. We cannot over-emphasize how

essential proper cleaning is to the maintenance

and continued use of your unit and the

avoidance of algae or bacteria build-up.

Regular Maintenance

1. Be sure the unit is OFF and is disconnected

from the electrical outlet.

2. Remove the Water Tank.

3. Empty water and minerals from the Base.

4. Drain the water from the Tank into the sink

and rinse tank thoroughly. Leave to dry.

5. Wipe the Heating Element clean with a soft

cloth after it has had a chance to cool. The

Electronic Thermal Control Heating Element

is lined with a non stick coating that is

designed to provide the easiest cleaning and

prolong the operating efficiency of the

Humidifier. DO NOT use any metal or hard

objects to clean the Heating Element

6. Re-place the tank and lid onto the base.

7. Follow Operating Instructions.

NOTE: Never use detergents, gasoline,

kerosene, glass cleaner, furniture polish,

paint thinner or and other household solvent

to clean any part of the Humidifier.

De-scaling Maintenance

Scale needs to be removed as it becomes

noticeable. We recommend using Bionaire

®

.

Clean Away - Humidifier cleaning solution. Apply

Solution with a plastic brush to scale surfaces.

Let it soak until residue is softened. For cleaning

the tank, mix 2 capsules of solution with 2 litres

of water. Let mixture stand for several minutes,

swishing every few minutes. Drain solution and

THOROUGHLY RINSE the tank.

1. Repeat steps 1-3 in the Maintenance section.

2. Clean the water chamber in the base by

adding 200ml of undiluted white vinegar,

then use a soft cloth to clean this part. If the

element is heavily scaled, add the vinegar as

explained above and plug the humidifier into

an electrical socket and turn it ON for no

longer than 15 seconds. After this time turn

the humidifier OFF and unplug it from the

electrical outlet.

Disinfect tank:

1. Fill tank with 1 teaspoon of bleach and 3.5

litres of water.

2. Let the solution stand for 20 minutes, shaking

every few minutes. Wet all surfaces.

2

3

BWM401I06MLM2.qxd 10/5/06 7:45 PM Page 4

Avaliação

Mais sobre este manual

Entendemos que é bom ter um manual em papel para o seu Bionaire BWM401 Humidificador. Você sempre pode baixar o manual em nosso site e imprimi-lo você mesmo. Se desejar um manual original, recomendamos que entre em contato com Bionaire. Eles podem fornecer um manual original. Você está procurando o manual do seu Bionaire BWM401 Humidificador em outro idioma? Escolha o seu idioma preferido em nossa página inicial e pesquise o número do modelo para ver se o temos disponível.

Especificações

Todos os manuais para Bionaire Humidificadores
Mais manuais de Humidificadores

Perguntas frequentes sobre Bionaire BWM401 Humidificador

Nossa equipe de suporte pesquisa informações úteis e respostas a perguntas frequentes sobre produtos. Se você encontrar algum dado incorreto em nossas perguntas frequentes, informe-nos usando nosso formulário de contato.

Produtos relacionados

Manual

Bionaire BU3000 Humidificador

Manual

Bionaire BWM001X Humidificador

Manual

Bionaire BUH004X Humidificador

Manual

Bionaire BU7000 Humidificador

Manual

Bionaire BU8000 Humidificador

Manual

Bionaire BUH003X Humidificador

Manual

Bionaire BU7500 Humidificador

Manual

Orbegozo HU 2028 Humidificador

Categorias relacionadas