Manual Aigostar 8433325500948 Ferro

Manual

4

2.Wait for a few seconds for the steam to penetrate the fibre before pressing

again.

NOTE : For the best steam quality, do not use more than three successive

bursts each time. Several pumping actions are needed to start this

function.

Excessive use of this feature will cause the iron to cool , ensure that

the pilot light is out, before operating the shot of steam control

Cleaning

1.Disconnect the appliance from the mains , before cleaning.

2.Do not use solvents or abrasive products to clean the iron , clean with a damp

cloth.

ANTI-DRIP

With the anti-drip system, you can perfectly iron even the most delicate fabrics.

Always iron these fabrics at low temperatures. The plate may cool down to the point

where no more steam comes out, but rather drops of boiling water that can leave

marks or stains. In these cases, the Anti-drip system automatically activates to

prevent vaporization, so that you can iron the most delicate fabrics without risk of

spoiling or staining them.

Defects and repairs

Do not attempt to replace a defective mains lead .The appliance has to be

returned to an authorized service centre for repair.

Faults-reasons and solutions

Iron emits an odor or smoke

Iron gives off an odor when turned on for the first time. Oils used during

manufacture need to be burnt off allow ten minutes for odor to disappear.

Iron does not heat

The iron should be plugged into a 230 Volt , AC electrical outlet only. The

temperature dial must be set at the desired temperature.

Iron does not steam

The water tank many be empty. Turn the steam valve to “0” and add

water .Allow the iron to heat, and then set the steam dial to the steam setting.

Burst of steam feature does not work

The water tank must be at least 1/4 full .Temperature must be set to steam

position. Iron should be in the horizontal position. Prime pump briefly. Allow a

short pause between shots. Be sure to fully depress the burst of steam button.

Spry mist feature does not work

The water tank must be at least 1/4 full. Fill the iron as described in the section

“how to fill the water tank”.

Iron is leaking

The variable steam dial must be set on” “,until the iron is hot . The temperature

setting is too low to produce steam. Shot of steam used too much, allow iron to

re-heat.

Warranty: 2 Years

Avaliação

Mais sobre este manual

Entendemos que é bom ter um manual em papel para o seu Aigostar 8433325500948 Ferro. Você sempre pode baixar o manual em nosso site e imprimi-lo você mesmo. Se desejar um manual original, recomendamos que entre em contato com Aigostar. Eles podem fornecer um manual original. Você está procurando o manual do seu Aigostar 8433325500948 Ferro em outro idioma? Escolha o seu idioma preferido em nossa página inicial e pesquise o número do modelo para ver se o temos disponível.

Especificações

Todos os manuais para Aigostar Ferros
Mais manuais de Ferros

Perguntas frequentes sobre Aigostar 8433325500948 Ferro

Nossa equipe de suporte pesquisa informações úteis e respostas a perguntas frequentes sobre produtos. Se você encontrar algum dado incorreto em nossas perguntas frequentes, informe-nos usando nosso formulário de contato.

Produtos relacionados

Manual

Aigostar 8433325500931 Ferro

Manual

Aigostar 310000HGB Ferro

Manual

Aigostar 8433325500986 Ferro

Manual

Aigostar 8433325500955 Ferro

Manual

Aigostar 310000QNM Ferro

Manual

Aigostar 310000RSN Ferro

Manual

Aigostar 310000PYF Ferro

Manual

Aigostar 8433325500993 Ferro

Categorias relacionadas